Combi Rig

What you need to create a Combi Rig:

A hook of your Choice, we have used a
R-LongShanker, Silicone Tubing,

Sinew Supple Braid and Phantom Fluorocarbon Hooklink

Tie a Figure of Eight loop knot

Once the loop knot is tied cut around 10cm of
Sinew off the spool

Now cut a small piece of Silicone tubing & thread it on to a Splicing needle

Slide the Silicone Tubing on to the 10cm of
Sinew Supple Braid

Place the hook point in the bore of the silicone and slide it down the hook (be careful not to split it)

secure the hook using the Knotless Knot

Once the Knotless Knot is tied, position the Silicone Tubing on the shank of the hook

Now take around 20cm of your Phantom fluorocarbon hooklink and fold over around 5cm at one end like below, next pass the braided end section you created earlier through the doubled over section of Fluorocarbon

Holding the hook and fluorocarbon loop between your left hand thumb and forefinger whip the supple braid around the doubled over section of Fluorocarbon. Between 5 and 7 Turns will be sufficient. Try to keep the whipping turns close together and fairly tight.

Now whip back over the top of the previous whipping towards the hook, 2 or 3 turns will do the job nicely. Then pass the tag end back through the loop of the fluorocarbon.

Moisten the knot, then tease it down with your thumb and forefinger. Once you've done this use your knot puller tool to fully tighten the knot